鸿御(上海)国际贸易有限公司

从事货物进口及技术进口业务,轴承,电线电缆,建筑材

新闻中心
  • 暂无新闻
联系方式
  • 联系人:赵先森
  • 电话:0510-81207777
  • 邮件:524085168@qq.com
  • 手机:13311666672
  • 传真:0510-88711788
您当前的位置:首页 » 供应产品 » 镇江INA轴承K7X10X8调心机能的校对应用
镇江INA轴承K7X10X8调心机能的校对应用
发布时间:2018-10-12
 镇江INA轴承能自动补偿轴承的硬性偏差和轴承中点的中点线,从而保证轴承的异常状态。

Zhenjiang INA bearing can automatically compensate for the hardness of the bearing deviation and bearing midpoint line, thus ensuring the abnormal state of the bearing.

由于轴承座孔的偏离、轴的加工和安装、以及后轴在载荷作用下的弯曲变形,在任何情况下都不可能使轴与内外环重叠。轴的挠度将导致轴承外侧的应力分布不均匀。轴承的后期成形将起到一定的作用。因此,像往常一样,即使需要渐进的装置方案,对于具有大绕组变形的零件,也应选择具有良好对准的轴承。

It is impossible to overlap the shaft with the inner and outer rings under any circumstances due to the deviation of the bearing seat hole, the machining and installation of the shaft, and the bending deformation of the rear shaft under the action of load. The deflection of the shaft will cause uneven distribution of stress on the outside of the bearing. The later forming of bearings will play a certain role. Therefore, as usual, even if a gradual device scheme is required, bearings with good alignment should be selected for parts with large winding deformation.

首先,坚持镇江INA轴承及其周围环境的清洁,即使进入轴承的微小无形灰尘,也会增加轴承的磨损、振动和音乐。

First of all, adhere to the Zhenjiang INA bearing and its surrounding environment clean, even into the bearing of the tiny invisible dust, will increase bearing wear, vibration and music.

其次,要小心使用该设备,以便冲压力强,不允许锤子间接突破轴承,不允许相对敏锐的压力。

Secondly, the device should be used with care so that the stamping force is strong, the hammer is not allowed to break through the bearing indirectly, and relatively sensitive pressure is not allowed.

第三,即使不使用布料和短纤维,也可以使用适当和精度性的设备对象来应用不相关的对象。

Third, even if cloth and staple fibers are not used, appropriate and accurate device objects can be used to apply unrelated objects.

第四,为了防止镇江INA轴承的腐蚀,须及时用足够的汗水清洗轴承,然后高品质的矿物油在旱季和夏季油漆作业中应特别注意防锈。然而,在一些特殊情况下,轴承可以更好地用于传统的计算,特别是在轻载条件下。这些不相关的操作的前提是,当旋转表面(轨道和旋转部件)是用于分离和定义污染物的有用的光滑膜时,会发生外部损伤。

Fourth, in order to prevent the corrosion of Zhenjiang INA bearings, it is necessary to wash the bearings with enough sweat in time, and then high-quality mineral oil in dry season and summer paint operations should pay special attention to rust prevention. However, in some special cases, bearings can be better used for traditional calculations, especially under light load conditions. The premise of these unrelated operations is that external damage occurs when the rotating surface (orbits and rotating parts) is a useful smooth membrane for separating and defining pollutants.

轴承的清洁度对向心推力球镇江INA轴承的使用寿命有很大的影响。结果,差异是几倍甚至几十倍。向心推力球轴承越清洁,其余实验的寿命就越长:不同清洁度的光滑油对球轴承的寿命有很大的影响。因此,改进后的润滑油的清洁度可延长向心推力球轴承的使用寿命。另外,向心推力球轴承的寿命是否稳定,油粒是否会乘以10米?

The cleanliness of the bearing has great influence on the service life of the centripetal thrust ball Zhenjiang INA bearing. As a result, the difference is several times or even dozens of times. The cleaner the centripetal thrust ball bearing, the longer the life of the rest of the experiments: different cleanliness of the smooth oil has a great impact on the life of the ball bearing. Therefore, the cleanliness of the improved lubricating oil can extend the service life of the centripetal thrust ball bearings. In addition, whether the life of the centripetal thrust ball bearing is stable and whether the oil particles will be multiplied by 10 meters?

(1)清洁度对振动的影响严重影响向心推力球镇江INA轴承的振动程度,尤其是高频振动。Gao Jie轴承的振动频率较低,尤其是在高频段。

(1) The influence of cleanliness on vibration seriously affects the vibration degree of Zhenjiang INA bearing with centripetal thrust, especially the high frequency vibration. The vibration frequency of Gao Jie bearing is low, especially in the high frequency section.

(2)研究了粉尘对径向推力球润滑脂噪声的影响。结果表明,粉尘越多,噪声越大。

(2) the effect of dust on the noise of radial thrust ball grease was studied. The results showed that the more dust, the greater the noise.

 

文章来自:镇江SKF轴承 www.wh-skf.com

The article is from: Zhenjiang SKF bearing www.wh-skf.com

文章来自:镇江INA轴承 www.ina-china.cn

The article is from: Zhenjiang INA bearing www.ina-china.cn

文章来自:镇江NSK轴承 www.klbbearings.com

The article is from: Zhenjiang NSK bearing www.klbbearings.com

 

QQ:524085168

电话:0510-81207777

手机:13311666672